I
NSTALLATION
English
19
Using the IR emitter
Normally, the Lifestyle
®
remote can control all of your
source devices. However, in rare cases, some of your
source devices may not operate correctly under control of
the Lifestyle
®
remote–for example, if your source devices
are stored in a cabinet with doors. The remote will operate
the Lifestyle
®
system, but may not properly operate your
other source devices depending on their placement. To
overcome this problem, you can use one or both of the
supplied IR emitters.
F i g u r e 1 4
IR emitters
To use the IR emitter
If only one of your source devices is not responding:
1.
Plug the IR emitter cord connector into the
Lifestyle
®
media center
IR emitter
connector.
2.
Temporarily position the emitter so that the flat side
is against the front panel of the source device.
N o t e :
DO NOT attach the supplied adhesive pad until
you have tested emitter operation as explained below.
3.
Using the Lifestyle
®
remote, press the
On/Off
button for that device.
Slowly move the emitter around while pressing the
remote On/Off button until the device responds.
4.
Using the adhesive pad, attach the emitter to the
device.
If two or more devices are not responding:
1.
Plug the IR emitter extender cord connector into
the Lifestyle
®
media center.
Optionally, plug the IR emitter cord connector into
the IR emitter extender.
2.
Place one or both IR emitters in a location near the
devices, such as on the shelf supporting the devices.
3.
Using the Lifestyle
®
remote, press the
On/Off
button for each device.
Slowly move the emitter(s) around while pressing
the remote On/Off button for each of the devices
until all devices respond.
4.
Using the adhesive pad(s), attach the emitter(s).
IR emitter
IR emitter extender
