en
Preventing material damage
26
Preventing material dam-
age
Follow these instructions to avoid ma-
terial damage and damage to the ap-
pliance.
Sensitive optical sensors and
components
Very sensitive optical sensors and
other delicate components are in-
stalled in your device.
Take care that you handle it carefully.
Avoid applying any external forces to
the device.
¡
Avoid any violent shocks to the
device or dropping it.
¡
Do not step on the device.
Legal disclaimer
BSH accepts no responsibility or liab-
ility for material damage due to non-
compliance with the following safety
instructions.
¡
This appliance supports only wash-
able garments at the moment.
¡
This appliance can analyze gar-
ments that consist of one or two
fibers only.
¡
This appliance supports stains that
are larger than the bottom glass
(1.5 cm diameter).
¡
Garment analysis accuracy may be
affected by inhomogeneous color
patterns, moisture, or special types
of dark dyeing.
¡
Garment and stain analysis accur-
acy may be affected by small tex-
tile thickness.
Proper use
Observe the following safety instruc-
tions in order to avoid personal injury
and damage to property.
¡
Only charge the appliance using
the charging cable included.
¡
Only connect and operate the
charging cable as specified on the
rating plate.
¡
Only store and charge the appli-
ance indoors.
¡
To make best use of the battery
capacity, the appliance should be
stored and operated at room tem-
perature.
¡
Do not expose the appliance to
temperatures below 0 °C or above
40 °C.
¡
Do not use the charging cable if it
is damaged. Replace it with an ori-
ginal charging cable.
¡
When disconnecting the charging
cable from the mains, pull the plug
itself to remove it – do not pull on
the power cord.
¡
Do not pull the charging cable
over sharp edges or allow it to be-
come trapped.
¡
Do not use a damaged appliance.
¡
In the event of a fault, switch off
the appliance and disconnect it
from the charging cable and the
mains.
¡
For safety reasons, only authorised
after-sales service personnel are
permitted to carry out repairs and
fit replacement parts to the appli-
ance.
¡
In the following cases, you must
stop using the appliance immedi-
ately and contact the after-sales
service:
– If liquid has entered the inside of
the appliance.
– If the appliance has been
dropped and damaged.
