Faults and what to do about them
en
33
Spin result not satisfac-
tory.
Laundry wet/too damp.
■
Wash small and large items of laundry together.
■
Speed selected too low?
Spin cycle activated
several times.
Not a fault – unbalanced load detection system adjusts imbalance.
Compartment
M
is not
rinsed out completely.
Remove the insert. Clean the detergent drawer and insert it
Odour formation in the
washer dryer.
■
Run the
Fluff Clean
l
90°C
programme without laundry.
■
Use standard detergents.
Status display
N
flashes.
Foam may come out of
the detergent drawer.
Too much detergent used?
■
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
dispenser
II
. (Not for outdoor, sports and down-filled textiles!)
■
Reduce detergent dosage for the next wash cycle.
■
Use commercially available low foam detergent and care products which
are suitable for washer dryers.
Excessive noise, vibra-
tions and “wandering”
during spin cycle.
■
Appliance aligned? Align the appliance
■
Are the appliance feet fixed? Secure appliance feet
■
Transportation safety devices removed? Remove the transportation bolts
Display panel/indicator
lights do not function
while the appliance is run-
ning.
■
Power failure?
■
Fuse tripped? Switch on/replace fuse.
■
If the fault occurs repeatedly, call the customer service
The programme duration
changes during the wash
cycle.
■
Not a fault – unbalanced load detection system adjusts imbalance.
■
Not a fault – foam detection function active. Additional rinse cycle.
Detergent residue on the
washing.
■
Occasionally phosphate-free detergents contain water-insoluble residues.
■
Select Spin/
Rinse
0
/
O
or brush items when the laundry is dry.
Spin noise during the
drying phase.
This is an innovative process known as thermal spinning used to reduce energy
consumption during the drying phase.
Different coloured fluff
from the previous drying
cycle is deposited on the
laundry during the
subsequent wash cycle.
Run the
Fluff Clean
l
cold
programme without laundry to remove fluff which
has collected in the washer drum during the drying phase.
Water inlet noise during
the drying phase, the tap
symbol flashes during the
drying phase.
The washer dryer runs a self-cleaning cycle to remove fluff which was deposited
by the laundry during the drying phase. This requires a little water. Therefore,
the tap must be turned on even during the drying phase.
Faults
Cause/Remedy
