Bosch WVG3046SIN, Инструкция по эксплуатации и руководство по установке

Страница: 37 / 48

Changing programme default settings
en
37
Soaking
1.
Pour soaking agent/detergent into
dispenser
II
according
to the manufacturer’s instructions.
2.
Set the programme selector to
i
Cottons 60°C
and select
A
Start/Reload
3.
After approximately 10 minutes
select
A
Start/Reload
to pause the
programme.
4.
After the required soaking time,
reselect
A
Start/Reload
if the
programme is to be continued or
change the programme.
Note:
Load laundry of the same colour.
No additional detergent is required,
the soaking solution is used for
washing.
0
Changing programme
default settings
Changing programme default settings
You can change the default settings for
selected programmes. The settings can
be changed even while the selected
programme is running. The effects
depend on the progress of the
programme.
6
Temp. °C
(
: The indicated washing
temperature can be changed. The
maximum selectable washing
temperature varies depending on the
selected programme.
Overview of programmes
~
Page 33
0
Spin Speed
0
: The spin speed can be changed
before and during the programme (in
rpm, revolutions per minute) depending
on the progress of the programme.
Setting
- - - -
(
Rinse stop
= without final
drain/spin cycle), laundry remains in the
water after the last rinse cycle.
Setting
0
(Without any spin cycle), drain
the rinsing water only, no spin cycle.
The maximum spin speed depends on
the programme and model.
Overview of programmes
~
Page 33
ñ
Ready in
8
: Define the Finish in time (end
of programme).
Note:
The respective programme
duration is displayed by selecting
the programme. The programme
duration is automatically adjusted while
the programme is running if the
programme duration needs to be
changed, e.g. due to changes in the
programme default settings.
Before the programme starts, the end of
the programme can be preselected in
hourly increments up to a maximum of
24h
.
When the programme has started,
the preselected time is displayed e.g.
8h
and counts down until
the programme starts. Then the
programme duration is displayed,
e.g.
2:30
.
When the programme has started,
the preselected time can be changed
as follows:
1.
Touch the
A
Start/Reload
button.
2.
Touch the
ñ
Ready in button
and change the Finish in time.
3.
Touch the
A
Start/Reload
button.