en
Positioning and connecting
42
Electrical connection
Electrical safety
:
Warning
Risk of electric shock!
Danger of death if live parts are
touched.
■
When disconnecting the main plug,
always pull the plug itself and not the
cable, otherwise the cable could be
damaged.
■
Never touch or hold the mains plug
with wet hands.
■
Never pull out the mains plug during
operation.
■
Only connect the washer dryer to an
alternating current using a correctly
installed earthed socket.
■
The mains voltage must be the same
as the voltage specifications on the
washer dryer (appliance rating
plate).
■
The connected load and the required
fuse are also indicated on the
appliance rating plate.
Ensure that:
■
The mains plug and socket match.
■
The cable cross-section is adequate.
■
The earthing system has been
installed correctly.
■
A damaged power cord is only
replaced by an electrician.
A replacement mains cable can be
obtained from customer service.
■
You do not use multiple plugs/
couplings or extension cables.
■
If a residual-current-operated circuit
breaker is used, you use only a type
which features this symbol:
z
.
Only this symbol guarantees
compliance with the currently valid
regulations.
■
The mains plug is always accessible.
■
The power cord is not kinked,
crushed, altered or severed and has
not come into contact with any heat
sources.
Before washing/drying for the
first time
The washer dryer was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum Clean
Û
programme the first
time
without
laundry.
Note:
■
The washer dryer must have been
installed and connected properly.
Installation and connection
~
Page 37
■
Never switch on a damaged washer
dryer. Inform your customer
service.
~
Page 35
1.
Insert mains plug.
2.
Turn the tap on.
3.
Switch on the appliance.
4.
Close the door. Do not load any
laundry.
5.
Select the
Drum Clean
Û
40°C
programme.
6.
Open the detergent drawer.
7.
Pour approx. 1 litre of water into
dispenser
II
.
8.
Add standard detergent to
dispenser
II
according
to manufacturer’s instructions for
light soiling.
Note:
To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
9.
Close the detergent drawer.
10.
Select
A
Start/Reload
.
11.
When the programme ends, switch
off the appliance.
Your washer dryer is now ready for
use.
