en
Faults and what to do about them
36
3
Faults and what to do about them
Faults and what to do about them
Faults
Cause/remedy
Please empty the con-
densate container
on
the display panel and the
drying cycle is inter-
rupted.
■
Empty the condensate container;
and the dryer;
■
If the optional condensation drain is installed, the drain hose may be
blocked. Check the hose for deposits and flush the hose out.
Please clean the fluff
filters
on the display
panel.
Clean the fluff filter and press the Start button
Heat exchanger is
being rinsed
on the dis-
play panel.
Not a fault. The heat exchanger is cleaned automatically. Do not pull out the
condensate container while this is displayed.
Dryer does not start.
■
Mains plug plugged in or fuse checked?
■
program selected? Select a program.
■
Dryer door open? Close the door.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Finish in" time selected? Program starts after a delay
.
Creasing.
■
Creasing occurs when you have exceeded the maximum load or selected
the wrong program for the type of fabric. All the required information can
be found in the program table
■
Remove clothes immediately after drying; creasing may occur if they are
left in the drum.
Water is leaking out.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Change in the pro-
gramme duration dis-
played during drying.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).
* depending on the model
Содержание WTY877690W
Страница 1: ...en Installation and operating instructions Tumble dryer WTY877690W ...
Страница 42: ...6 ...
Страница 43: ...6 ...