en
Faults and what to do about them
30
3
Faults and what to do about them
Faults and what to do about them
Faults
Cause/remedy
ð
on the display panel
and drying has been inter-
rupted.
■
Empty the condensate container and press the Start button.
■
If the optional condensation drain has been installed, the drain hose may be
blocked or kinked. Check the hose for deposits and flush the hose out.
Make sure that the hose does not have any kinks when it is in place.
ç
on the display panel.
ç
on the display panel
even though the fluff filter
and the EasyClean filter
have been cleaned.
It is important to proceed in the order set out in the section entitled
.
Note:
The appliance must be switched on when it is cleaned.
Dryer will not start.
■
Start button selected?
■
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Is the childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Programme starts after a delay.
Creasing.
■
Creasing occurs when you have exceeded the maximum permitted load or
selected the wrong programme for the type of fabric. All the required infor-
mation can be found in the programme table.
■
Remove clothes immediately after drying; creasing may occur if they are
left in the drum.
Water is leaking out.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Change in the pro-
gramme duration dis-
played during drying.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).
* Depending on the model
Содержание WTH83008IT
Страница 1: ...en Installation and operating instructions Tumble dryer WTH83008IT ...
Страница 35: ...6 ...
