Bosch WTG86419GR, Инструкция по установке и эксплуатации

Страница: 30 / 40

en
Setting the signal and current
30
M
Setting the signal and
current
Setting the signal and current
You can change the following settings:
■
The spin speed that was used for
spinning in the washing machine;
used exclusively to more accurately
display the anticipated drying time,
■
the volume of the audible signal at
the end of the programme,
■
the volume of the audible button
signals,
■
the current rating for your dryer's
fuse (10 A or 13 A).
Note:
The values for the energy
label are determined using a circuit
breaker/fuse rating of 13 A. If the
circuit breaker/fuse rating is
changed to 10 A, the drying time
and energy consumption will be
higher. You can find details on this in
the consumption values table.
~
Page 37
You will need to activate setting mode
before you can change these settings.
Activating setting mode
1.
Switch the dryer on.
2.
Select the "Cottons" programme in
position 1 and wait for five seconds.
Setting mode is now activated. The
symbols go out on the display panel
and the programme duration is
displayed.
1.
Press and hold the Start button and,
at the same time, turn the
programme selector clockwise to
position 2.
2.
The
spin speed
is shown on the
display.
3.
Press the "Ready in" time button or
the drying time button to change the
spin speed.
4.
Turn the programme selector
clockwise to position 3.
5.
The volume for the
audible signal at
the end of the programme
is shown
on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
6.
Press the "Ready in" time button or
the drying time button to change the
volume.
7.
Turn the programme selector
clockwise to position 4.
8.
The volume for the
audible button
signal
is shown on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud