Bosch WTG8640XME, Инструкция по установке и эксплуатации

Страница: 26 / 36

en
Setting the signal and current
26
Emptying the condensate
container
By default, the condensation from the
appliance runs into the condensation
container.
Alternatively, you have the option of
discharging the condensation water *
supplied depending on the model. If you
choose to discharge the condensation
water into the waste-water system, you
will not need to empty the condensation
container during the drying programme
or after each time you use the dryer.
1.
Pull out the condensate container
horizontally.
2.
Pour out the condensation water.
Caution!
Dirty condensation water may be
harmful to your health and cause
material damage.
Condensation water is not suitable
for drinking and may be
contaminated with fluff. Do not drink
the condensation water or reuse it.
3.
Push in the condensate container
until you feel it lock back into place
in the dryer.
M
Setting the signal and
current
Setting the signal and current
You can change the following settings:
■
The spin speed that is used for
spinning your laundry before it is
dried,
■
The volume of the audible signal at
the end of the programme,
■
The volume of the audible button
signals,
■
The current rating for your dryer's
fuse (10 A or 16 A).
Note:
The values for the energy
label are determined using a circuit
breaker/fuse rating of 16 A. If the
circuit breaker/fuse rating is
changed to 10 A, the drying time
and energy consumption will be
higher. You can find details on this in
the consumption values table.
~
Page 33
* into the waste-water system via a
drain hose