Bosch WTA79200GB, Инструкция по установке и эксплуатации

Страница: 33 / 40

Faults and what to do about them
en
33
3
Faults and what to do about them
Faults and what to do about them
Faults Cause/remedy
ç
on the display panel.
■
Clean the fluff filter. Select the Start button to reset the displayed indication and
then select the Start button again to restart the appliance if necessary.
■
Check if exhaust air duct is blocked or bent. Clean the exhaust air duct
~ Page 32 . If necessary, clean the insect screen on the exhaust air pipe.
Dryer does not start.
■
Mains plug plugged in or fuse checked?
■
Start button selected?
■
Dryer door open? Close the door.
■
Program selected? Select a program.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Program starts after a delay.
Display panel goes off and
Start button flashes.
Not a fault. Energy saving mode is active
~
Page 12 .
Programme terminates
shortly after starting.
■
Ambient temperature greater than 5 °C?
■
Is the appliance loaded with the laundry?
■
Load too small for selected programme? Use timed programme.
■
Loaded laundry dry?
The door opens by itself. Push the door closed until you hear it engage.
Creasing.
■
Creasing occurs when you have exceeded the maximum load or selected the
wrong program for the type of fabric. All the required information can be found
in the program table.
■
Remove clothes immediately after drying. Creasing may occur if they are left in
the drum.
Water is leaking out. Not a fault. The dryer may be positioned on an incline. Level the dryer.
Laundry is not dried cor-
rectly or is still too damp.
■
After the end of the program, warm laundry feels damper than it actually is.
Spread the laundry out and allow the heat to disperse.
■
Finely adjust the dryness level – this extends the drying time but does not
increase the temperature. Your laundry will become drier ~ Page 27 .
■
Select a program with a longer drying time or increase the drying level. This
does not increase the temperature.
■
Select a timed program for subsequent drying of laundry that is still damp
~
Page 25 .
■
If you have exceeded the maximum load for the program, the laundry may not
be dried properly.
■
Clean the moisture sensor in the drum. A fine layer of limescale or particles
from the detergent and care products used in washing may residue on the sen-
sor and adversely affect it performance. It may cause that your laundry will not
dry properly
~
Page 32 .
■
Drying has been interrupted as a result of a power cut, because the condensate
container is full or because the maximum drying time has been exceeded.
Note: See also the laundry tips
~
Page 24 .
* depending on the model