operation
en
29
operation
12 Basic operation
operation
Note:
You can find further information
in the digital instruction manual by
scanning the QR code in the table of
contents or on www.bosch-
home.com.
12.1 Switching on the appli-
ance
Requirement:
The appliance has
been correctly installed and connec-
ted.
→
"Installation and connection",
▶
Turn the programme selector to a
programme.
Note:
The lighting for the drum goes
out automatically.
12.2 Setting a programme
1.
Turn the programme selector and
set the required programme.
→
2.
If required, adjust the programme
settings.
12.3 Loading laundry
Note:
To prevent creasing, note the
maximum load for the programmes.
→
Requirements
¡
The laundry is prepared and sor-
ted.
→
¡
The drum is empty.
1.
Open the door.
2.
Place the laundry in the drum.
3.
Close the door.
Ensure that there is no laundry
trapped in the door.
12.4 Starting the programme
Requirement:
A programme is set.
"Setting a programme", Page 29
▶
Press
Start/
Reload
.
a
The display shows the programme
duration or the "Ready in" time.
a
After the programme has ended,
the display shows: "End" .
Note:
If "Hot" appears, the appliance
cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
12.5 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Requirement:
A programme has
started.
→
1.
Press
Start/
Reload
.
The cooling process starts auto-
matically after approximately 30
seconds and cools down the laun-
dry while the drum is rotating. If
you want to avoid or cancel the
cooling process, open the door.
→
2.
Open the door.
3.
Add or remove laundry.
4.
Close the door.
5.
Press
Start/
Reload
.
12.6 Cancelling the pro-
gramme
1.
Press
Start/
Reload
.
2.
Open the appliance door.
3.
Remove the laundry.
→
