operation
en
31
Notes
¡
The programme settings are not
saved permanently for the pro-
gramme.
¡
The setting is saved if you activate
or deactivate the intelligent dosing
system.
13.4 Loading laundry
Note:
To prevent creasing, note the
maximum load for the programmes.
→
Requirements
¡
The laundry is prepared and sor-
ted.
→
¡
The drum is empty.
1.
Open the door.
2.
Place the laundry in the drum.
3.
Close the door.
Ensure that there is no laundry
trapped in the door.
13.5 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip:
In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note:
Observe the information about
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
3.
If required, add the care product.
4.
Push in the detergent drawer.
13.6 Starting the programme
Requirement:
A programme is set.
"Setting a programme", Page 30
▶
Press
.
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows the programme
duration or the "Ready in" time.
a
After the programme has ended,
the display shows: "End".
13.7 Soaking laundry
Note:
No additional detergent is re-
quired. The washing solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
.
3.
To resume the programme, after
the desired soaking time, press
.
13.8 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement:
A programme has
started.
→
1.
Press
.
The appliance pauses.
Note:
If you want to add laundry,
follow the instructions on the dis-
play.
→
2.
Open the door.
3.
Add or remove laundry.
4.
Close the door.
5.
Press
.
