Control panel lock
en-us
25
2.
Pour in the detergent.
3.
If required, add the care product.
4.
Push in the detergent drawer.
13.6 Starting the program
Requirement:
A program has been set.
▶
Press
Start Pause
.
a
The drum rotates and load detection takes place. This
can take up to 2 minutes, after which water enters the
drum.
a
The display shows the program duration or the "Ready
in" time.
a
After the program has ended, the display shows:
End
.
13.7 Changing the activated "Ready in" time
If you have set and activated a "Ready in" time for a de-
layed program start, you can change the "Ready in" time
again before the program starts.
Requirements
¡
The program is set.
¡
The "Ready in" time is set and activated.
1.
Press
Start Pause
.
The activated "Ready in" time is paused.
2.
Press
Finish in
repeatedly until the display indicates
the desired "Ready in" time.
3.
Press
Start Pause
.
The changed "Ready in" time is activated.
13.8 Adding laundry
After the program starts, you can remove or add laundry
depending on the program status.
1.
Press
Start Pause
.
The appliance pauses.
Note:
If you want to add laundry, follow the instructions
on the display.
2.
Open the door.
3.
Add or remove laundry.
4.
Close the door.
5.
Press
Start Pause
.
13.9 Terminating the program
1.
Press
Start Pause
.
2.
Open the door.
The appliance door remains locked for safety reasons if
the temperature and water levels are high.
– If the temperature is high, start the
Rinse
program.
– If the water level is high, start the
Spin
program or
select a suitable program for draining.
3.
Remove the laundry.
"Removing the laundry", Page 25
13.10 Removing the laundry
1.
Open the door.
2.
Remove the laundry from the drum.
13.11 Switching off the appliance
1.
Turn the program selector to
Off
.
2.
Turn off the tap.
3.
Wipe the rubber gasket dry and remove any foreign ob-
jects.
4.
Leave the appliance door and detergent drawer open so
that residual water can evaporate.
Control panel lock
14 Control panel lock
Control panel lock
Secure your appliance against being operated unintention-
ally using the controls.
14.1 Activate control panel lock
▶
Press and hold the
Temperature
and
Finish in
buttons
for approximately 3 seconds.
a
The display shows
.
a
The controls are locked.
a
The control panel lock remains active even after the ap-
pliance has been switched off and in the event of a
power failure.
14.2 Deactivate control panel lock
Requirement:
To deactivate the control panel lock, the
appliance must be switched on.
▶
Press and hold the
Temperature
and
Finish in
buttons
for approximately 3 seconds.
a
goes out on the display.
