Cleaning and maintenance
en
37
AquaSensor
depending on the model
During the rinse cycle, the AquaSensor
checks the degree of turbidity (turbidity
is caused by dirt and detergent residue)
of the rinsing water. The duration and
the number of rinse cycles depend on
the turbidity of the water.
Load sensor/display
The load sensor detects the load level
in the washing machine when the door
is open. This is indicated by the bar
filling on the display panel.
Note:
In order for the load sensor to
fully determine the amount of laundry,
the drum must be empty before the
washing machine is switched on.
Dosing recommendation
The dosing recommendation indicates a
recommended detergent dosage as a
percentage, depending on the selected
programme and the detected load. The
indicated % refers to the dosing
recommendation of the detergent
manufacturer.
Note:
By adhering to the dosing
recommendation, you can help look
after both the environment and your
household budget.
2
Cleaning and
maintenance
Cleaning and maintenance
:
Warning
Danger of death!
There is a risk of electric shock if you
touch live components.
Switch off the appliance and pull out the
mains plug.
:
Warning
Risk of poisoning!
Toxic vapours can be produced by
cleaning agents that contain solvents,
e.g. cleaning solvent.
Do not use cleaning agents that contain
solvents.
Caution!
Damage to the appliance
Cleaning agents that contain solvents,
e.g. cleaning solvent, can damage
surfaces and components in the
machine.
Do not use cleaning agents that contain
solvents.
Prevent detergent residue from
building up and odours from forming
by following these instructions:
Notes
■
Ensure the room in which the
washing machine is set up is well
ventilated.
■
Leave the door and detergent
dispenser tray open slightly when
the washing machine is not in use.
■
Occasionally run a wash using the
Cottons 60 °C
programme and
powder detergent.
