Home Connect
en
43
1.
Set the programme to position 3.
a
The display shows
APP
.
2.
Press
Start/Reload
.
a
The appliance connects to the
Home Connect app.
3.
Once your appliance is displayed
in the Home Connect app, carry
out the last steps in the
Home Connect app.
a
If the display shows
con
, the appli-
ance is connected to the
Home Connect app.
15.4 Connecting the appli-
ance to the energy man-
ager
If you connect the appliance to the
smart energy system (energy man-
ager), you will optimise your energy
consumption. The appliance starts
only when your home photovoltaic
system can provide sufficient energy
or the energy tariff is good.
Requirements
¡
The smart energy system (energy
manager) must use the EEBus Initi-
ative communications standard.
¡
You have read about how to con-
nect your appliance to the smart
energy system (energy manager)
in the instruction manual for the
smart energy system (energy man-
ager).
1.
Press and hold
Remote Start
for
approx. 3 seconds.
a
The display shows
Aut
.
2.
Set the programme to position 7.
a
The display shows
EnG
.
3.
Press
Start/Reload
.
a
The appliance is connected to the
smart energy system (energy man-
ager).
a
If the appliance has connected to
the energy manager successfully,
the display shows
con
and .
4.
Activate Flex Start if you want the
smart energy system (energy man-
ager) to start up your appliance.
→
"Activate Flex Start", Page 43
Activate Flex Start
Activate Flex Start to allow your smart
energy system (energy manager) to
start your appliance once your home
photovoltaic system is able to
provide sufficient energy or the en-
ergy tariff is good.
Requirement:
The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
1.
Set the programme you require.
2.
Press
- Finished in
+
to set the
required time.
3.
Press
Start/Reload
.
4.
Press
Remote Start
.
a
The display shows and Flex
Start is activated. The appliance
waits to be started by the smart
energy system (energy manager).
a
If the time changes on the display,
e.g. to 8 h, the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a
If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following
circumstances:
¡
Press
Start/Reload
.
¡
Open the door.
