NL Troubleshooting
Malfunction
"E:30 / -80"
Cause and Troubleshooting
▶
When dosing manually, reduce the amount of
detergent for the next wash with an equal load.
Unauthorized extension mounted on the water drain
hose.
▶
Remove any unauthorized extensions from the
water drain hose. Connect device
Pump cover is not fully screwed in.
▶
Make sure that the pump cover is screwed into the
device as far as it will go. The pump cover handle
must be vertical.
"E:36 / -25 / -26"
Drain pump is clogged.
▶
"Cleaning the drain pump", page 39
"E:38 / -25 / -26"
Drain pump is clogged.
▶
if the fault is displayed again,
▶
"Cleaning the drain pump", page 39
Inlet opening of the rubber sleeve is clogged.
▶
"Clean the inlet opening in the rubber sleeve",
"E:10 / -00 / -10 /
- 20"
Pump of the intelligent dosing system is blocked.
1.
Switch off the device.
2.
Clean the pump unit.
"Cleaning the detergent drawer",
3.
If the indication reappears, enable the service.
Remark: You can start the washing program if you
deactivate the intelligent dosing system and dose
manually.
Water pressure is low.
No solution possible.
The strainers in the water supply are clogged.
▶
Clean the strainers in the water supply.
Water tap is closed.
▶
Open the water tap.
Water supply hose is kinked or pinched.
44