Bosch WAW28660GB, Инструкция по эксплуатации и руководство по установке

Страница: 40 / 56

en
Faults and what to do about them.
40
Faults and what to do about them.
Faults Cause/Remedy
Water is leaking out.
■
Attach the drain hose correctly or replace it.
■
Tighten the screw connection of the drain hose.
The machine is not filling
with water.
Detergent is not being
dispensed.
■
Have you pressed the
A
button?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter.
~
Page 37
■
Is the supply hose kinked or trapped?
The dispenser is empty
and fill level indicator is
not flashing.
■
Is the drawer cover/connector dirty? Clean the detergent drawer.
~
Page 34
■
Has the detergent drawer been pushed in correctly?
~
Page 28
The wrong detergent/
fabric softener has been
poured into the
dispenser(s).
Dispenser(s):
1. Empty and clean.
~
Page 34
2. Refill.
~
Page 29
Detergent/fabric softener
has congealed in the
dispensers.
Clean and refill the dispensers.
The door cannot be
opened.
■
The safety function is activated. Stop the programme?
~
Page 27
■
Is
$
selected (Rinse Stop = no final spin)?
~
Page 27
■
Can the door only be opened by the emergency release?
~
Page 38
The programme will not
start.
■
Have you pressed the
A
button or selected
Finished In
time?
■
Is the door closed?
■
Is the
E
childproof lock activated? Deactivate it.
■
If
ù
flashes, the detergent drawer has not been pushed in completely.
Push the detergent drawer in correctly.
The drum briefly jerks or
judders after the
programme has started.
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
The water is not draining.
■
Is
$
selected (Rinse Stop = no final spin)?
~
Page 27
■
Clean the drain pump.
~
Page 36
■
Clean the drain pipe and/or the drain hose.
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not
satisfactory.
Laundry is wet/too damp.
■
Not a fault – the unbalanced load detection system has interrupted the spin
cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
■
Is Reduced Ironing selected (depending on the model)?
~
Page 24
■
Is the selected speed too low?
The spin cycle runs
several times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
www.devicemanuals.eu/