en
Positioning and connecting
20
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory.To
remove any water that may be left over
from the test, run the first wash cycle
without
any laundry.
Notes
■
The washing machine
must be
correctly
installed
and
connected
.
■
Never use a machine if it is
damaged. Inform the after-sales
service.
Preparatory work:
1.
Check the machine.
2.
Remove the protective film from the
control panel.
3.
Plug in the mains plug.
4.
Turn on the tap.
Running the programme without
laundry:
1.
Switch on the appliance.
2.
Close the door (do not load any
laundry).
3.
Set the
i
Cottons
90 °C
programme.
4.
Open the detergent drawer.
5.
Pour approximately 1 litre of water
into compartment
II
.
6.
Pour standard washing powder into
compartment
II
.
Note:
To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer.Do not use detergents
intended for woollens or delicates.
7.
Close the detergent drawer.
8.
Press the
A
button.
9.
Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
