Bosch WAV28MH9GB, Руководство пользователя и инструкции по установке, Страница: 43 / 68

Home Connect
en
43
4.
Activate Flex Start if you want the
smart energy system (energy man-
ager) to start up your appliance.
→
"Activate Flex Start", Page 43
Activate Flex Start
Activate Flex Start to allow your smart
energy system (energy manager) to
start your appliance once your home
photovoltaic system is able to provide
sufficient energy or the energy tariff is
good.
Requirement:
The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
1.
Set the programme you require.
2.
Press
- Finished in +
to set the re-
quired time.
3.
Press
Start / Reload
.
4.
Press
Start / Reload
.
a
The display shows ⁠ and Flex Start
is activated. The appliance waits to
be started by the smart energy sys-
tem (energy manager).
a
If the time changes on the display,
e.g. to 8 h, the smart energy system
(energy manager) has established a
time at which your appliance can
start.
a If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends. The
programme ends when the time
period ends.
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡
Press
Start / Reload
.
¡
Open the door.
¡
Switch off the appliance.
¡
Power failure.
Remote diagnostics
Customer Service can use Remote Dia-
gnostics to access your appliance if
you contact them, have your appliance
connected to the Home Connect server
and if Remote Diagnostics is available
in the country in which you are using
the appliance.
Tip:
For further information and details
about the availability of Remote Dia-
gnostics in your country, please visit
the service/support section of your
local website: www.home-connect.com
Data protection
Please see the information on data pro-
tection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
¡
Unique appliance identification (con-
sisting of appliance codes as well as
the MAC address of the Wi-Fi com-
munication module installed).
¡
Security certificate of the Wi-Fi com-
munication module (to ensure a se-
cure data connection).
¡
The current software and hardware
version of your appliance.
¡
Status of any previous reset to fact-
ory settings.
This initial registration prepares the
Home Connect functions for use and is
only required when you want to use the
Home Connect functions for the first
time.
Note:
Please note that the Home Con-
nect functions can only be utilised with
the Home Connect app. Information on
data protection can be retrieved in the
Home Connect app.