en
Troubleshooting
48
Fault
Cause and troubleshooting
"E:30 / -10" and/or
1.
First wait approx. 5 minutes until the drain process
ends.
2.
To reset the error message, switch the appliance
off.
3.
Switch the appliance back on.
4.
If the error message is displayed again, call cus-
tomer service.
→
The detergent drawer has not been pushed in fully.
▶
Push in the detergent drawer until the symbol goes
out.
The pump unit is not inserted.
1.
Insert the pump unit into the detergent drawer.
→
"Cleaning the detergent drawer", Page 41
2.
Push in the detergent drawer until the symbol goes
out.
flashes.
The automatic voltage control system detects an un-
authorised voltage under-usage.
▶
No remedial action possible.
Note:
If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
▶
If intelligent dosing is activated, reduce the basic
dosage →
.
▶
If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
lights up.
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
"Cancelling the programme", Page 33
Water level is too high.
▶
Select a suitable programme for draining.
→