Operating the appliance
en
35
Note:
Foam detection
If the
Å
symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent to the next wash
cycle with the same load.
If you want to lock the program to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.
Childproof lock
(
E
3sec.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock when the
program has started
.
To
activate/deactivate
, press and hold
the
(
0
rpm)
and
ñ
Finished In
buttons
at the same time after the washing
program has started. Keep pressing the
two buttons for approx. three seconds.
The
E
symbol appears in the display
panel.
■
E
lights up: The childproof lock is
active.
■
E
flashes: The childproof lock is
active and the program selector has
been adjusted. To deactivate the
childproof lock, reset the program
selector to the initial program. The
symbol lights up again.
Note:
To avoid the program to
terminate, do not turn the program
selector beyond the Off position.
Note:
The childproof lock remains
active after the program has ended and
the appliance is switched off. You must
always deactivate the childproof lock if
you want to start a new program.
Adding/removing laundry
Following the start of the program, you
can add or remove laundry as required.
Press the
A
Start/Reload button to do
this.
The
A
Start/Reload button indicator
lamp flashes and the machine checks
whether it is possible to add laundry.
If the following appears in the display
panel:
■
The
Õ
symbol disappears: adding
laundry is possible.
■
The
Õ
symbol lights up: it is not
possible to add laundry.
To continue the program, press the
button
A
Start/Reload. The program
continues automatically.
Notes
■
Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
■
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
■
The load display is not active during
reloading.
Changing the programme
1.
Press the
A
Start/Reload button.
2.
Select another program.
3.
Press the
A
Start/Reload
button.The new program starts from
the beginning.
