en
operation
30
13.8 Changing the activated
"Ready in" time
If you have set and activated a
"Ready in" time for a delayed pro-
gramme start, you can change the
"Ready in" time again before the pro-
gramme starts.
Requirements
¡
The programme is set.
→
"Setting a programme", Page 28
¡
The "Ready in" time is set and ac-
tivated.
→
1.
Press
Start / Reload
.
The activated "Ready in" time is
paused.
2.
Press
Finish in
repeatedly until the
display indicates the desired
"Ready in" time.
3.
Press
Start / Reload
.
The changed "Ready in" time is ac-
tivated.
13.9 Soaking laundry
Note:
No additional detergent is re-
quired. The washing solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
Start / Re-
load
.
3.
To resume the programme, after
the desired soaking time, press
Start / Reload
.
13.10 Adding laundry
1.
Press
Start / Reload
.
The appliance pauses.
Note:
If appears, it is not pos-
sible to add laundry.
When goes out, it is possible to
add laundry.
2.
Open the appliance door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
Start / Reload
.
13.11 Cancelling the pro-
gramme
1.
Press
Start / Reload
.
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
Rinse
programme.
– If the water level is high, start
the
Spin
programme or select a
suitable programme for draining.
→
3.
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡
Rinse Stop is activated.
→
¡
The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1.
Set the
Spin
programme or a pro-
gramme for draining the water.
→
2.
Press
Start / Reload
.
13.13 Unloading the laundry
1.
Open the appliance door.
2.
Remove the laundry.