Bosch WAN series, Инструкция по эксплуатации и руководство по установке

Страница: 35 / 44

Cleaning and maintenance
en
35
4.
Take the drain hose out of the
retainer.
Remove the sealing cap and allow
the water to flow out into a suitable
container.
Replace the sealing cap and place
the drain hose in the retainer.
5.
Carefully unscrew the pump cover;
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the drain pump must be
able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
6.
Place the service flap back on, lock
it into place, and close it.
Note:
To prevent unused detergent
from flowing straight into the drain
during the next wash, pour 1 litre of
water (without detergent) into
compartment
II
and start the
Drain/
Empty
programme. Do the next wash
as usual.
Drain hose at the siphon is
blocked
1.
Switch off the appliance. Disconnect
the mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3.
Clean the drain hose and siphon
connecting piece.
4.
Reattach the drain hose and secure
the connection using the hose
clamp.
Filter in the water supply is
blocked
:
Warning
Risk of electric shock!
The Aqua-Stop contains an electric
valve. There is a risk of electric shock if
you immerse the Aqua-Stop safety valve
in water. Do not immerse the safety
valve in water.
First, reduce the water pressure in the
supply hose:
1.
Turn off the tap.
2.
Select any programme (except
Rinse/Spin/Drain/Empty).
3.
Press the Start Reload
A
button.
Allow the programme to run for
approximately 40 seconds.
4.
Turn the programme selector to the
off position. Disconnect the mains
plug.
5.
Clean the filter on the tap:
Disconnect the hose from the tap.
Clean the filter with a small brush.