Bosch WAL28PHBSN, Руководство пользователя

Страница: 64 / 76

en
Troubleshooting
64
Fault Cause and troubleshooting
Loud noises during
the spin cycle.
▶
Secure the appliance feet. Aligning the appliance
Transit bolts have not been removed.
▶
Removing the transit bolts
Banging noises, rat-
tling in the drain
pump. Foreign bodies have got into the drain pump.
▶
→ "Cleaning the drain pump", Page 52
Slurping, rhythmical
suction noise. The drain pump is active, the detergent solution is
pumped out.
▶
Not a fault – normal operating noise.
Creasing. The spin speed is too high.
▶
The next time you run a wash cycle, set a lower
spin speed.
The load is too large.
▶
The next time you run a wash cycle, reduce the
amount of laundry being loaded.
The wrong programme is selected for the type of fab-
ric.
▶
Select the programmes that are suitable for the
type of fabric.
→
"Programmes", Page 27
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp. A low spin speed is selected.
▶
The next time you run a wash cycle, set a higher
spin speed.
▶
Start the
Centrif.
programme.
is activated.
▶
Select the programmes that are suitable for the
type of fabric.
→
"Programmes", Page 27
Drain pipe or water outlet hose is blocked.
▶
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶
Ensure that the drain pipe and water drain hose are
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the drum.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.