Bosch WAK20200GC, Инструкция по эксплуатации и руководство по установке

Страница: 26 / 40

en
Faults and what to do about them.
26
Information on the display
panel
Faults and what to do about
them.
Display Cause/remedial action
YES The washing machine door is unlocked. It is possible to add laundry.
NO
■
The temperature is too high. Wait until the temperature falls.
■
Water level too high. Not possible to add laundry. If necessary, close the wash-
ing machine door immediately. To continue the programme, press
Start
/
Reload
A
.
¼
flashes
■
Laundry may be caught. Please open and close the washing machine door
again and press Start /Reload
A
.
■
If necessary, push the washing machine door closed or remove the laundry and
push it closed again.
■
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
E:17
■
Turn the water tap on fully,
■
The supply hose is kinked/trapped,
■
The water pressure is too low. Clean the filter.
E:18
■
The detergent solution pump is blocked. Clean the detergent solution pump.
■
The drain hose/waste pipe is blocked. Clean the drain hose at the siphon.
E:23 Water in the base tub, appliance leaking. Turn off the water tap. Call the after-sales
service.
E
The childproof lock is activated; to deactivate:
9
flashes Too much foam detected, a rinse cycle has been switched on.
: The mains voltage is too low.
.
Undervoltage in the wash programme.
The programme is extended.
Other displays Switch off the appliance, wait for 5 seconds and switch it back on again. If the dis-
play appears again, call the after-sales service.
Faults Cause/remedial action
Water is leaking out.
■
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
No water supply.
Detergent not dispensed.
■
Start /Reload
A
not pressed?
■
Tap not turned on?
■
Filter blocked? Clean the filter.
■
Supply hose kinked or trapped?