Bosch WAK20160GR, Инструкция по эксплуатации и руководство по установке

Страница: 36 / 40

en
Positioning and connecting
36
■
The mains cable is only replaced by
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
■
No multiple plugs/couplings or
extension cables are used.
■
If an earth-leakage circuit breaker is
used, only a type which displays this
symbol is used:
z
.
Only this symbol guarantees
compliance with the currently
applicable regulations.
■
The mains plug can be accessed at
all times.
■
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle
without
any laundry.
Notes
■
The washing machine
must be
correctly installed
and
connected
.
From
~
Page 31
■
Never use a damaged machine.
Inform your after-sales service.
1.
Check the machine.
2.
Remove the protective film from the
control panel.
3.
Connect the mains plug.
4.
Turn on the water tap.
5.
Close the washing machine door (do
not load any laundry).
6.
Select the
i
Cottons
programme
and set the temperature to
90 °C
.
7.
Open the detergent drawer.
8.
Pour approx. 1 litre of water into
compartment
II
.
9.
Pour standard detergent into
compartment
II
.
Note:
To prevent foaming, only use
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
for wool or delicates.
10.
Close the detergent drawer.
11.
Press
Start
.
12.
Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
supply hose.
Maintenance – filter in the water
supply
~
Page 24
3.
Drain the remaining detergent
solution.
Maintenance – detergent solution
pump blocked
~
Page 23
4.
Disconnect the washing machine
from the mains.
5.
Remove the hoses.
Installing the transport locks:
1.
Remove the covers and keep them
in a safe place.
Use a screwdriver if necessary.
2.
Insert all four sleeves.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.