Bosch WAK20060ID, Инструкция по эксплуатации и руководство по установке

Страница: 21 / 36

Faults and what to do about them.
en
21
3.
Press
Start
/Pause
A
. Allow the
programme to run for approximately
40 seconds.
4.
Set the programme selector to off
position. Disconnect the mains plug.
5.
Clean the filter on the water tap:
Remove the hose from the water tap.
Clean the filter with a small brush.
6.
For standard and Aqua-Secure
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance,
Remove the filter using pliers and
clean the filter.
7.
Connect the hose and check for
leaks.
3
Faults and what to do
about them.
Faults and what to do about them.
Emergency release
e.g. in the event of a power outage
The programme will continue running
when the power supply has been
restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.
Wait until the drum has stopped turning.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washing machine door
if water can be seen through the glass.
1.
Switch off the appliance. Disconnect
the mains plug.
2.
Drain the detergent solution
.
3.
Pull the emergency release
downwards with a tool and release.
The washing machine door can then
be opened.