Bosch wae28462gb, Инструкция по эксплуатации и руководство по установке

Страница: 22 / 36

en
Cleaning and maintenance
22
Detergent solution pump
blocked
:
Warning
Risk of scalding!
When washing at high temperatures, the
detergent solution becomes hot. If you
come into contact with the hot detergent
solution, you may be scalded.
Allow the detergent solution to cool
down.
1.
Turn off the water tap so that no
more water can flow in and has to be
drained via the detergent solution
pump.
2.
Switch off the appliance. Pull out the
mains plug.
3.
Open and remove the service flap.
4.
For models:
–
With a drainage hose
: Remove
the drainage hose from its holder
and remove the sealing cap.
Allow the detergent solution to
flow out into a suitable container.
Replace the sealing cap on the
drainage hose, and place the
drainage hose back in its holder.
–
Without a drainage hose:
:
Carefully unscrew the pump
cover until the detergent solution
begins to flow out.
When the service flap is half full,
close the pump cover and drain
the service flap.
Repeat the above steps until all
the detergent solution has
completely drained out.
5.
Carefully unscrew the pump cover;
residual water may leak out.
Clean the interior, pump-cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit and screw on the pump cover.
The handle must be in a vertical
position.
6.
Put the service flap back on, lock it
into place and close it.
Note:
To prevent unused detergent
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into compartment
II
and start the
Empty
programme.