Bosch VJD-8000, Руководство по установке

Страница: 16 / 28

Configuration
This chapter is intended for the administrator of the video management system. The setup
process depends on the video management system in use. Refer to the corresponding
documentation for details. In this manual, the setup with the Bosch Video Client system is
explained as example.
Setting up the decoder with Configuration Manager
Before you can operate the unit within your network, it must have a valid IP address for your
network and a compatible subnet mask.
Notice!
As a default DHCP is enabled in the unit’s network settings.
With an active DHCP server in the network you must know the IP address assigned by the
DHCP server to operate the unit.
The following default address is preset at the factory: 192.168.0.1
For the latest version of the Configuration Manager, go to http://www.boschsecurity.com and
download it from the Software tab of the corresponding product page.
In Configuration Manager, the decoder currently is detected in the same way as other
hardware, various information is displayed, and further configuration options are provided. In
the following, the configuration pages found in the Configuration Manager for the decoder are
listed, and the different settings explained.
Notice!
Changes do not become effective until you click in the toolbar.
Find more information in the documentation for the Configuration Manager.
Unit Access tab
Identification
In this group, assign a unique name and ID for the decoder in order to make administering of
multiple units easier in larger installations.
Password
In this group, you can protect the decoder against unauthorized access.
The decoder works with two password levels. The service level is the highest level of
authorization. With this level of access, after entering the required password, users can use all
functions of the decoder and change all configuration settings. The user level enables users to
make and break connections or switch layouts, but does not provide access to configuration.
Device access (main tab My Devices only)
This group controls access from the Configuration Manager to the decoder. Here, you can
configure settings to determine which protocol and which HTTP port are used for
communication between the Configuration Manager and the decoder.
If the decoder is password-protected, the correct user name and password must be entered
here.
Version information
In this group, you can view the hardware, firmware versions and serial number of the decoder.
6
6.1
6.1.1
16 en | Configuration VIDEOJET decoder 8000
2015.08 | V1 | DOC Installation Manual Bosch Security Systems B.V.