Bosch Universal HedgePole 18 Скачать руководство пользователя страница 21

Страница: 21 / 356

English |

There is danger of injury when unintentionally actuating
the On/Off switch with the locking button.

Tool assembly (see figure C and E)

Fit the hedge trimmer head and the telescopic handle flush
together with each other and secure them by screwing the
connector

(3)

on. Ensure both parts are fitted properly

mounted and locked.
Attach the hooks of the shoulder strap

(8)

to the strap

loops

(7)/(9)

of the handles. Please notice that the shoulder

strap has two hooks that are different in size. Make sure that
the larger hook

(16)

is fitted to the rear handle strap

loop

(9)

and the smaller hook

(15)

to the front handle strap

loop

(7)

Remove the blade guard.

Adjusting the telescopic height (see figure F)

Loosen the telescopic height adjustment

(5)

by rotating the

sleeve, extend the telescopic tube

(4)

to the required length

and tighten the sleeve of the telescopic height
adjustment

(5)

again.

The telescopic tube

(4)

can be extended from 2.1 m to

2.60 m depending on the application and the height of the
trimmed head.

Adjusting the pivoting head (see figure H)

Press two pivoting head adjustment buttons

(2)

simultan-

eously, adjust the pivoting head to the required position by
moving the hedge trimmer head upwards or downwards, re-
lease the pivoting head adjustment buttons

(2)

and make

sure that the hedge trimmer head is properly locked.

The pivoting head can be adjusted to 10 different positions.

Operation

Switching on and off (see figure I)

switch on

the power tool, first press the lock-off

switch

(10)

and then press the On/Off switch

(12)

. Keep the

On/Off switch pressed while operating the machine. You can
release the lock-off switch while the tool is switched on.
To

switch off

the power tool, release the On/Off switch

(12)

The lithium-ion battery is protected against deep discharge
by the Electronic Cell Protection (ECP). When the battery is
discharged, the power tool is switched off by means of a pro-
tective circuit: The application tool no longer rotates.

Working instructions (see figure J)

Anti Blocking

This tool has the anti-blocking system installed for your be-
nefit.
If the blade stalls on a tough material, the load of the motor
increases. The intelligent micro-electronics senses this over-
load condition and repeatedly reverses the motor, in order
to prevent stalling and to cut the branch through.
This audible reversing cut action continues for up to 3 s.
After cutting through, the garden product continues in its
normal mode, or in case the overload condition continues,
the blades automatically stop in the open position (e.g. in
case a piece of metal fence accidentally blocks the garden
product).

Troubleshooting

The following chart lists problem symptoms, possible causes and corrective action, if your machine does not operate properly.
If these do not identify and correct the problem, contact your service agent.

Warning: Switch off and remove the battery prior to
any troubleshooting.

Telescopic hedge trimmer

Problem

Possible Cause

Corrective Measure

Cutting time per bat-
tery charge too low

Too much friction, due to lack of lubricant

Apply lubricant spray (1 609 200 399)

Blade needs cleaning

Clean blade

Poor cutting technique

see "Working Advice"