Bosch TRONIC 6000C WH17, Руководство по установке и эксплуатации

Страница: 14 / 24

6 720 646 951 (2015/04) Tronic 6000C
14 | Installation
Canada Wiring - auxiliary terminal block and connections
Fitting the auxiliary terminal block (see diagram below).
Fig. 9 For Canada only (Not for U.S.A.)
Fig. 10 For Canada only (Not for U.S.A.)
▶ Connect the red wires from the left hand terminal of the
new block to the L1 terminals in the unit. (There are two red
wires required in the WH17 and three in the WH27).
▶ Connect the blue wires from the right hand terminal of the
new block to the L2 terminals in the unit. (There are two
blue wires required in the WH17 and three in the WH27).
▶ Mount the auxiliary terminal block onto the provided
backplate using the mounting holes.
Connecting the supply cable - Canada only - not for the USA.
• The power cable size and the installation must be in
accordance with the Canadian Electrical Code, C22.1-02.
• The incoming hole diameter on auxiliary terminal block can
accept up to 1/0 AWG size cables.
• The cable entry is via the 1 ¼ inch cable entry hole on the
bottom right hand edge of the backplate.
• Strip back the insulation on the power wires about ½ inch.
Connect the ungrounded conductors to the terminals “L1”
and “L2” on the auxiliary terminal block.
• Any insulation on the ground wire should be stripped back
about ¾ inch. The ground lead must be connected to the
pillar terminal marked “GR.”
• Make sure the terminal block screws are tightened
securely. Loose connections can cause wires to heat up.
• Make sure that the ground wire is wrapped around its
terminal stud and into the saddle washer. The nut should be
tightened securely.
• Attach the front cover, replace the white bushing with flat
end facing up, replace the knob in any orientation by
pushing down to secure and tighten the retaining screws.
The WH17 requires an 80A 240V AC
single phase supply protected by an 80A
double pole circuit breaker.
The WH27 requires a 120A 240V AC
single phase supply protected by a 120A
double pole circuit breaker.