1 695 104 941
2008-10-17
|
Robert Bosch GmbH
Adjustments | TCE 4510 | 21
en
If he rollers are not aligned proceed as follows:
Remove the side covers n°57 and n°60;
1.
Loosen the rear adjustment screws n°11;
2.
Extract the support n°10;
3.
Introduce remove the spacers n°7 until achievement
4.
of the correct distance;
Remount the support;
5.
Pull the adjustment screws until preventing the slid-
6.
ing of the arm (in order to adjust the sliders);
Loosen the adjusters a half turn;
7.
Check correct sliding along the entire stroke length
8.
Tighten the counter-nuts.
9.
Self-centering chuck sliding table
3.6
adjustment
Check procedure of the appropriate functioning of the
self-centering chuck, of the sliders and replacement of
the reducer gear.
Correct functioning check:
Mount a wheel on the self-centering chuck;
1.
Check that there are no excessive plays on the self-
2.
centering chuck table;
If there are excessive plays of the device proceed as
follows:
Disconnect power supply;
3.
Open the RT side door;
4.
Remove the self-centering chuck:
5.
Extract the central shaft;
$
Unscrew the central locking nut with a 14mm long
$
wrench;
Extract the self-centering chuck;
$
Extract the plastic transmission bushings;
$
Remove the central connection that maintains the
$
tool aligned with the axis;
Remove the two metal sheet closing covers.
$
Disconnect the clip of the hydraulic cylinder N°2
6.
releasing thus the self-centering chuck;
Unscrew the support screws of the right sliding slid-
7.
ers;
Proceed with adjusters replacement;
8.
Warning: for an easier assembling it is adviced to
$
use a generous quantity of grease, to maintain all
pieces in position.
