Bosch SPV40C00GB, Руководство по эксплуатации

Страница: 16 / 28

en
16
Timer programming
Timer programming *
* depending on model
You can delay the start of the programme
by 3, 6 or 9 hours.
–
Switch on ON/OFF switch
(
.
– Keep pressing the Preselected starting
time button
0
until the appropriate
display 3h, 6h or 9h is lit.
– Press START button
h
, timer
programming is activated.
– To delete the preselected starting time,
keep pressing the Preselected starting
time button
0
until none of the
displays 3h, 6h or 9h is lit.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the End
display
`
is lit.
The end of the programme is also
indicated by an acoustic signal. The
buzzer volume can be set in 4 stages.
Accordingly 0, 1, 2 or 3 displays are lit
(see water hardness table). Factory
setting: 2. This function can be changed
as follows:
–
Open the door.
– Switch on ON/OFF switch
(
.
– Hold down button >
P
and press
START button
h
until the End display
`
and salt refill indicator
)*
flash.
– Release buttons.
– Keep pressing button >
P
until the
salt refill indicator
)*
and rinse aid
refill indicator
)"
flash.
– Release buttons.
The refill indicators
)*
and
)"
flash
and the displays
#
and
+
are lit
(= Setting 2). The set buzzer volume
can be heard.
To change the setting,
– Press the button <
H
until the
required setting has been selected.
– Press START button
h
.
The displays go out. The selected
setting is saved.
– Close the door.
Note
To save energy, the dishwasher
automatically switches off after 2 minutes
after the end of the programme.
Switching off the appliance
Short time after the end of the programme:
–
Open the door.
– Switch off ON/OFF switch
(
.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Remove the utensils when they have
cooled down.
ã=
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
– Open the door.
– Switch off ON/OFF switch
(
.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
– To continue the programme, switch on
the ON/OFF switch
(
again.
– Close the door.