Bosch SMV6ZCX42N, Инструкция по эксплуатации

Страница: 29 / 68

Softening System NL
Note Set the device to the
determined water hardness.
→ "Setting water softening",
Page 29
With a water hardness of 0 - 6 °dH you
do not need to use softening salt and
you can switch off the water softening.
→ "Switch off water softening",
Page 30
water hardness, the greater the
amount of softening salt required.
PAY ATTENTION!
s Dishwasher detergent can damage the water
damage hardening.
▶
The reservoir of the softener
Only fill the water supply with
special salt for dishwashers.
s The rinse aid container can be
corrode softening salt.
▶
To ensure that
spills softener salt from the
rinse aid container is rinsed, the
softener salt is filled into the
softener salt reservoir
immediately before the program
starts.
Set water softening
Set the appliance to the water
hardness.
1.
Determine the water hardness and
the desired setpoint.
→ "Overview of the water hard-
health settings", page 28
2.
on to press.
3.
Approx. 3 seconds on
to access the basic settings.
Busy-
1.
Open the lid of the softening salt
reservoir and remove it.
a The display shows H:xx
reflected
2.
When using for the first time: fill the
reservoir completely with water. to give.
a The display shows
to give.
4.
Just as often on
the desired water hardness has
been set.
or
press to
The factory setting is H:04.
5.
To save the settings, press for
approx. 3 seconds.
Softening salt
You can soften the water with
softening salt.
Filling softening salt
If the Refill softener salt indicator
lights up, top up the softener salt in
the softener salt reservoir
immediately before the start of the
programme. The required amount of
softening salt depends on the water
hardness. The higher the
29