Bosch SMU8EDS01A, Руководство пользователя

Страница: 56 / 64

aus
Troubleshooting
56
Fault Cause and troubleshooting
Refill indicator for
rinse aid does not
light up. Rinse aid system is switched off.
▶
Set the amount of rinse aid to be dispensed.
Fault Cause and troubleshooting
Water is left in the ap-
pliance at the end of
the programme. Filter system or area under the filters is blocked.
1.
Clean the Filters → Page 43 .
2.
Clean the Wastewater pump → Page 59 .
Programme has not yet ended.
▶
Wait until the programme ends or cancel the pro-
gramme with
Reset
.
▶
→ "Terminate programme", Page 35
Appliance cannot be
switched on or oper-
ated. Software update is taking place.
▶
Wait until the software update has finished.
Appliance functions have failed.
1.
Pull out the mains plug or switch off the fuse.
2.
Wait at least 2 minutes.
3.
Connect the appliance to the power supply.
4.
Switch the appliance on.
Appliance does not
start. The mains fuse has tripped.
▶
Check the relevant fuse.
Mains cable is not inserted.
1.
Check whether the socket works.
2.
Check whether the mains cable is properly inserted
in the socket and on the rear of the appliance.
Appliance door is not closed properly.
▶
Close the appliance door.
Programme starts
automatically. You did not wait until programme ended.
▶
→ "Terminate programme", Page 35
Appliance stops dur-
ing the programme or
cuts out. Appliance door is not closed properly.
▶
Close the appliance door.
Power and/or water supply has been interrupted.
1.
Check the power supply.
2.
Check the water supply.
Top basket is pressing against inner door and pre-
venting appliance door from being closed securely.
▶
Check whether the rear panel of the appliance is
being pressed in by a socket or hose holder that
has not been removed.