
Troubleshooting
en
45
Fault
Cause
Troubleshooting
Water marks on plastic
parts.
Due to laws of physics
droplet formation on plastic
surfaces is unavoidable.
After drying water marks are
visible.
▶
Select a more intensive pro-
gramme.
▶
Position tableware at an angle.
▶
Use rinse aid.
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your "detergent"
▶
Clean the appliance mechanically.
White coating is deposited in
the appliance interior.
Special salt dispenser is not
screwed tight.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your "detergent"
▶
Clean the appliance mechanically.
The hardness range is set in-
correctly or the water hard-
ness is greater than 62 °E
(8,9 mmol/l).
3in1/organic/eco detergent
is not effective enough.
Too little detergent is being
used.
▶
Increase the amount of detergent
used or change "Detergent "
Washing programme selec-
ted too weak.
▶
Select a more intensive washing
programme.
▶
Adjust the sensitivity of the sensors.
Tea residue or lipstick marks
on tableware.
Washing temperature is too
low.
▶
Select a programme with a higher
washing temperature.
Too little detergent is being
used or is unsuitable.
▶
Use a suitable "Detergent "
turer's instructions for the amount
to be used.
Содержание SMS6HMW27Q
Страница 55: ......