Bosch SMI88TS01W, Инструкция по эксплуатации

Страница: 35 / 54

Operating the appliance
en
35
Time preselection
You can delay the start of the
programme by up to 24 hours.
Depending on the setting of the time
display, the end of programme is
indicated with “Finish in” (for example
3h 25m) or “Finish at” (for example
15:20 hours).
1.
Open the door.
2.
Switch on ON/OFF switch
(
.
3.
Selects programme
0
.
4.
Press time preselection button
`
.
5.
Keep pressing the setting buttons
+ -
X
until the displayed time
corresponds with your requirements.
6.
Press START button
)"
, timer
programming is activated.
7.
To delete the time preselection,
press START button
)"
for approx.
3 seconds.
Time preselection was terminated.
8.
Close the door.
Programme end
* The programme has ended when
“Finished” is indicated on the display
window at the top
@
and on the front
display *
):
.
* The end of the programme is
displayed on the floor – provided the
TimeLight (optical display) is switched
on and is visible.
* depending on the features of your
dishwasher
Switching off the appliance
Short time after the end of the
programme:
1.
Open the door.
2.
Switch off ON/OFF switch
(
.
3.
Turn off tap (does not apply to
appliances with Aqua-Stop).
4.
Remove the utensils when they have
cooled down.
Note:
When the programme ends,
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.
Interrupting the programme
Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close.
1.
Open the door.
2.
Switch off ON/OFF switch
(
.
The LEDs go out. The programme
is saved.
3.
To continue the programme, switch
on the ON/OFF switch
(
again.
4.
Close the door.