en
Rinse aid system
30
¡
The water hardness is 0 - 8 °E.
You do not need to use special
salt.
1.
Press .
2.
To open the basic settings, press
for 3 seconds.
a
The display shows H:xx.
a
The display shows
.
3.
Press or repeatedly until the
display shows H:00.
4.
To save the settings, press
for 3 seconds.
a
The water softening system is
switched off and the salt refill indic-
ator is deactivated.
Rinse aid system
Rinse aid system
Rinse aid system
Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
1.
Press the catch on the lid of the
dispenser for rinse aid and lift
.
1
2
2.
Add rinse aid up to the max mark.
max
3.
If rinse aid spills out, remove it
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
4.
Close the lid of the dispenser for
rinse aid.
a
The lid clicks into position.
Setting the amount of rinse
aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
1.
Press .
2.
To open the basic settings, press
for 3 seconds.
a
The display shows H:xx.
a
The display shows
.
3.
Press
repeatedly until
the display shows the value set at
the factory r:05.
4.
Press or repeatedly until the
right amount of rinse aid has been
set.
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
– A higher setting adds more
rinse aid during the wash cycle,
reduces water marks and im-
proves the drying result.
