en-us
Troubleshooting
48
Issue
Cause and troubleshooting
Water spots on
plastic parts.
Droplet formation on plastic surfaces is unavoid-
able due to the laws of physics. Water spots are
visible after drying.
▶
Select a more intensive program.
▶
Position dishware at an angle.
▶
Use rinse aid.
▶
Set the water softening system higher.
Wipeable or water-
soluble coatings in-
side the appliance
or on the door.
There is detergent residue. These coatings can-
not generally be removed with chemicals.
▶
Change your Detergent.
▶
Scrub the appliance by hand.
White coating is deposited inside the appliance.
1.
Adjust the water softening system correctly.
In most cases you will need to increase the
setting.
2.
If necessary, change your detergent.
Special salt dispenser is not screwed tight.
▶
Screw the special salt dispenser tight.
There are stubborn
white coatings on
the dishware, inside
the appliance or on
the door.
There is detergent residue. These coatings can-
not generally be removed with chemicals.
▶
Change your Detergent.
▶
Scrub the appliance by hand.
Hardness range is set incorrectly or the water
hardness is too high.
▶
Set the Water softening system to the water
hardness or add special salt.
3in1/organic/eco detergent is not effective
enough.
▶
Set the Water softening system to the water
hardness and use separate detergents (name
brand, special salt, rinse aid).
Too little detergent is being used.
▶
Increase the amount of detergent used or
change Detergent .
Selected wash cycle is too light.
▶
Select a more intensive cycle.
▶
Adjust the sensitivity of the sensors.