Water softening system
en-us
23
Water hard-
ness °E
Hardness
range
mmol/l
Setting value
13 - 15
medium
1.9 - 2.1
H:03
16 - 20
medium
2.2 - 2.9
H:04
21 - 26
hard
3.0 - 3.7
H:05
27 - 38
hard
3.8 - 5.4
H:06
39 - 62
hard
5.5 - 8.9
H:07
Note: Set the water hardness de-
termined on your appliance.
With a water hardness of 0 - 8 °E
you can dispense with special salt
for dishwashers and switch off the
water softening system.
"Switching off the water soften-
9.2 Setting the water
softening system
Set the water hardness on your
appliance.
1.
Determine the water hardness
and the appropriate setting
value.
2.
Press
.
3.
To open the basic settings,
press
for 3 seconds.
a
The display shows H:xx.
a
The display shows
.
4.
Press
repeatedly until the
right water hardness has been
set.
The value H:00 is set at the
factory.
5.
To save the settings, press
for 3 seconds.
9.3 Special Dishwasher
Salt
You can use special dishwasher
salt to soften the water.
Adding dishwasher salt
If the salt refill indicator lights up,
add special dishwasher salt to the
dispenser for salt just before the
cycle starts. The amount of spe-
cial dishwasher salt required de-
pends on the water hardness. The
higher the water hardness, the
greater the amount of salt re-
quired.
NOTICE:
Detergent may damage the water
softening system.
▶
Only fill the dispenser of the
water softening system with
special dishwasher salt.
Special salt for dishwashers can
damage the tub due to corrosion.
▶
To make sure that any special
salt that escapes is washed out
of the tub, add the special salt
to the dispenser for special salt
immediately before the pro-
gram starts.
1.
Unscrew the lid of the salt dis-
penser and remove.
2.
Before the first use: Fill the dis-
penser full with water.
