Troubleshooting
en-us
49
Issue
Cause and troubleshooting
All LEDs light up or
flash.
Electronics have detected a fault.
1.
Press the main switch button for approx. 4 sec-
onds.
The appliance is reset and restarted.
2.
If the problem occurs again:
‒
Switch off the appliance.
‒
Unplug the power plug or switch off the cir-
cuit breaker in the fuse box.
‒
Wait at least 2 minutes.
‒
Switch on the circuit breaker in the fuse box
or plug in the power plug.
‒
Switch on the appliance.
3.
If the problem occurs again:
‒
Contact customer service.
UP appears on the
display.
A software update is available.
▶
Press the remote start button to install the soft-
ware update.
a
After a successful software update, "Suc" ap-
pears on the display for a few seconds.
Water is left in the
appliance at the end
of the program.
Filter system or area under the filters is blocked.
1.
2.
Program has not yet ended.
▶
Wait until the program ends or terminate the
program with Reset.
▶
"Terminating the wash cycle", Page 30
Appliance cannot be
switched on or oper-
ated.
Software update is taking place.
▶
Wait until the software update has finished.
Appliance functions have failed.
1.
Pull out the power cord plug or switch off the
breaker.
2.
Wait at least 2 minutes.
3.
Connect the appliance to the power supply.
4.
Switch the appliance on.
Appliance does not
start.
The breaker has tripped.
▶
Check the relevant breaker.
Power cord is not inserted.
1.
Check whether the power outlet is working.
Содержание SHE53B75UC
Страница 59: ......