en
7
Close the door.
Hold down programme button B and
press
1
main switch until the digital
display illuminates, then release the
buttons.
The LED for button B flashes and
the digital display displays the factory
setting
.
To change the setting,
press programme button B .
Each time the button is pressed, the set
value increases by 1; after
, the
setting goes back to
.
Switch off the main switch
1
. The
chosen setting has now been stored.
Filling the salt dispenser
Salt must always be filled before the
appliance is switched on, so that excess
salt solution is immediately flushed away
to prevent corrosion.
Open the screw-type cap of the
compartment
24
.
Before using the appliance for the first
time, pour about 1 litre of water in the
salt container.
Then refill with salt (not cooking salt)
until the salt container is full
(max. 1.5 kg). When you refill the salt,
water is being displaced and drains off.
The LOW SALT indicator
8
on the front
panel will light up initially but will extinguish
again after a short period when the salt
solution has become sufficiently
concentrated.
When the control is set to
, it is not
necessary to fill up with salt as none will
be consumed while the dishwasher is
operating. The LOW SALT indicator is
switched off. If the control is set between
and
, then salt must be added
to the dispenser.
Warning
Do not pour detergent into the container
for special salt. This would destroy the
water softener.
