2 | BLA1-CC Color Camera Modules
Series Application Information
Camera View
The camera's viewable area is shown below:
Note:
The camera's field of view varies depending on the
size of the detector on which it is mounted and the
height at which it is installed. The passive-infrared
(PIR) coverage patterns and look-down zone
shown are for reference only.
Top View
Field-of-view legend
PIR coverage pattern
look-down zone
camera's field of view
Side View
Power Considerations
Power Limits
Input power must be provided by an Approved Limited Power
Source. All outputs must be connected to SELV (Safety Extra-
Low Voltage) circuits only.
Standby Power
This detector has no internal standby battery. For UL Listed
product installations, 4 hr (20 mAh with camera off, 400 mAh
with camera on) of standby power must be supplied by the con-
trol unit or by a UL Listed burglary power supply.
BLA1-CC Color Camera Modules | 3
Video Connection
A video cable with a BNC connector at one end is supplied.
Connect this cable to up to 500 ft (152 m) of 75
Ω
RG59/U or
similar coaxial cable.
Series Technical Specifications
BLA1-CC Series Specifications
Enclosure Design
Color:
white
Dimensions (HxWxD):
2.2 in. x 2.4 in. x 1.9 in.
(5.6 cm x 6.1 cm x 4.8 cm)
Material:
High-impact ABS plastic
Environmental Considerations
Relative Humidity:
0 to 95%, noncondensing
Operating Temperature:
+14°F to +120°F (-10°C to +49°C)
For UL Listed product installations,
+32°F to +120°F (0°C to +49°C)
Input
Alarm:
5 V normally from sensor digital alarm
output, ground for 4 seconds during
alarm.
Outputs
Relay Timer:
Selectable latch time of 15 s or 90 s.
Timed Relay:
Solid state, selectable supervised Form
A normally-closed (NC) or unsuper-
vised Form B normally-open (NO) con-
tacts rated for 125 mA at 28 VDC, 3 W.
Tamper:
Normally-closed (NC) contacts (with
cover on) rated at 28 VDC, 125 mA
maximum. Connect to detector tamper
circuit.
Power Requirements
Current (Alarm):
100 mA when camera is on.
Current (Standby):
5 mA maximum at 12 VDC
Voltage (Operating):
10 VDC to 14 VDC
Radio Frequency
Interference (RFI)
Immunity:
No alarm or setup on critical frequen-
cies in the range from 26 MHz to
2000 MHz at 30 v/m.
Video
CCD:
1/3-inch (8.5 mm) color with an elec-
tronic shutter
Lens:
3.6 mm fixed focal length lens
Resolution (horizontal):
330 lines minimum at center of picture
Scanning System:
2:1 interlaced
Sensitivity:
<3.4 lx
Signal:
75
Ω
(NTSC or PAL)
Signal to Noise Ratio:
45 dB minimum
