Bosch SE3000 Series, Руководство по установке оборудования

Страница: 30 / 40

30 en | System power-up and debug Security Escort
2018.03 | SE3v1.0 | DOC Hardware Installation Manual Robert Bosch (SEA) Pte Ltd
5 System power-up and debug
5.1 Initial system configuration
This is performed to check the hardware device and its wiring installation.
5.2 Powering up the system for the first time
1. Ensure SE coordinator and receiver are powered up.
2. In the Security Escort Central Console software, select the menu Setup > Transponder
current status . The following window appears:
3. Select the desired SE coordinator from the Transponder drop-down list box.
4. Click the [Reset Transponder Troubles] button. If the selected SE coordinator is
communicating with the Central Console, the number “1” will appear in the Total
Outgoing Messages and Successful Incoming Messages fields. The SE coordinator is
now communicating with the Central Console software. If the number “1” only appears in
the
Total Outgoing Messages field, there might be a problem between the Central
Console and the SE coordinator (refer to the section Troubleshooting SE coordinators,
points and SE receivers of this manual and locate the problem).
5. Check the Stress test checkbox. This tests the communications reliability by causing the
Central Console software to send a continuous stream of messages to the selected SE
coordinator. The values in the
Successful Incoming Messages and Total Outgoing
Messages fields should start counting up rapidly, with few, if any errors. It is normal to
have slightly fewer Total Outgoing Messages than Successful Incoming Messages . If the
errors are greater than 1% of the number of messages, then refer to the section
Troubleshooting SE coordinators, points and SE receivers of this manual and locate the
problem.
6. After the stress test runs, any current troubles are displayed. Correct any troubles at this
time.