Bosch Rextop IndraControl VCH 05.1, Руководство по эксплуатации

Страница: 19 / 32

10.3 Connecting to the Connection Module VAC
Refer to the documentation about the connection modules.
10.4 Software-Specific Settings
The software settings are described in the project planning manual "Rexroth
IndraControl V Devices Operating Systems" (see tab. 1-1 "Further documents"
on page 2 ).
11 Commissioning
General Information
For commissioning the control, further parameterization or programming is nec-
essary.
Commissioning steps
1. Before commissioning the hand-held terminal, the operator has to ensure
that the plant, especially the safety devices, are in a correct state.
Stopping the system due to connecting a
hand-held terminal with pressed stop but-
ton or EMERGENCY STOP pushbutton.
NOTICE
Before commissioning the hand-held terminal, ensure that the stop button
or the EMERGENCY STOP pushbutton is not pressed.
2. Connect the 17-pin connector to the VAC connection module.
3. Set up the hand-held terminal and the connection module (see project
planning manual "Rexroth IndraControl V Devices Operating Systems", tab.
1-1 "Further documents" on page 2 ).
Find further details about the commissioning in the documentation
of the device or system manufacturer.
VCH 05.1 Bosch Rexroth AG
Commissioning
DOK-SUPPL*-VCH*05*****-IT02-EN-P
15/27