8
Bosch Rexroth Corporation
Operating Instructions
The belt grinder will grind two belts at once, in a
single pass.
The proper bevel is absolutely
critical when welding TS
plus
transport belts.
To ensure proper operation, it is important that all
settings outlined on pages 5–7 are checked before
grinding belts, and that the following steps are
followed carefully.
WARNING!
To prevent serious injury, always observe the
following safety warnings:
•
Make sure all guards are securely in place
and all fasteners are tight.
•
NEVER wear loose-fitting clothing or
jewelry that could be pulled into the
grinding drum.
•
Long-hair MUST be tied back.
•
Because of the fine dust generated in the
grinding process, ALWAYS wear safety
glasses and a dust mask.
Preparing to grind the belts:
1. Turn the crank handle counterclockwise, moving
the table as far forward (toward the motor) as it
will go.
2. Raise the belt clamp handle and feed two belts
under the clamping bar and grinding drum, until
the ends of the belt are even with the front edge
of the table. Make sure the belts are straight and
parallel to the sides of the table and each other,
and that the ends of the belt are square with the
front edge of the table. See Figure 8.
IMPORTANT:
Make sure that you grind the
bottom
of the belt coming from the
drive
and
the
top
of the belt coming from the
return
. This
ensures smooth pallet transfer over the belt joint.
See Figure 9.
Fig. 9
Fig. 8
Belt Ends Even with
Edge of Table
Belts Straight and
Parallel to Each Other
and Sides of Table
