3.4 Explaining the signal alert symbol on the device
krax
If this symbol is on your device, you have to observe the documentation
on the device. The respective documentation informs on the type of
hazard as well as the steps required to avoid this hazard.
4 Intended use
The PR30 and VR30 control cabinet and panel PCs are PC-based machine
operator and visualization terminals. Depending on the application or
configuration, they can also meet the control functionality. The devices are
intended for the following use cases:
●
Operator terminals, visualization terminals and programming terminals with
an integrated soft control in stand-alone machines
●
Operator terminals, visualization terminals and programming terminals for
connected IndraControl controls
The device might be destructed if not the
expressly stated accessories, mounting parts
and other components, cables, lines, software
and firmware are used.
NOTICE
The PR30 and VR30 control cabinet and panel PCs may only be used as intended
and with the accessories, mounting parts and other components specified in
this documentation. Components that are not expressly mentioned must neither
be attached nor connected. The same applies to cables and lines.
Only to be operated with the component configurations and combinations
expressly defined and with the software and firmware specified in the
corresponding functional description.
Typical areas of application of the operator display:
●
Handling and assembly systems
●
Packaging and food processing machines
●
Printing and paper converting machines
●
Machine tools
●
Wood processing machines
The devices may only be operated under the mounting and installation
conditions, the position and the ambient conditions (temperature, degree of
protection, humidity, EMC etc.) specified in the related documentation.
PR30 and VR30 Control Cabinet PC and
Panel PC
5/45
Intended use
R911384706_Edition 01 Bosch Rexroth AG