MPH-02, MPB-02, MPD-02
Handling, Diagnostic and Service Functions
10-57
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
Fig. 10-22: Logbook entries (example)
Note:
Each time the control section is switched on "0xFFFFFFFF" is
entered in P-0-0478 as a separator in order to mark the "new
start".
The entries in P-0-0479 contain the operating hours of the control section
in seconds at the time of the respective event.
Fig. 10-23: Content of parameter P-0-0479 (example)
Patch Function
Brief Description
For reading and writing any storage location (or internal variable) as a
data object via the master communication, the analog output or the
oscilloscope feature, the patch function can be used.
In conjunction with the analog output or the oscilloscope feature this
functionality can be used for locating errors.
Note:
As it is a function for exclusive use by the development staff,
the patch display parameters P-0-0485 and P-0-0491 are
read- and write-protected with the master password. The
contents of these parameters are
not stored in the flash
but
are lost when the drive is switched off.
Courtesy
of
CMA/Flodyne/Hydradyne
▪
Motion
Control
▪
Hydraulic
▪
Pneumatic
▪
Electrical
▪
Mechanical
▪
(800)
426-5480
▪
www.cmafh.com
