Bosch Rexroth IndraControl VDP 40.3, Руководство по планированию проекта

Страница: 42 / 64

Name at
the
housing
Availability Connection type Connector
type, integrated
Mating
connector or
cable (from
outside)
XSER Only at
CDI
devices
CDI interface, data RJ45 socket RJ45 plug
XVID Only at
CDI
devices
CDI interface, image RJ45 socket RJ45 plug
XUSBIN Only at
CDI
devices
USB2.0 connection to
the control cabinet PC.
Length of 5 m max.
Only high-speed
USB2.0 cables may be
used (see chapter 11
"Ordering information"
on page 47 )
USB socket,
4-pin, type B USB plug,
4-pin, type B
XCDI+rx Only at
CDI+
devices
CDI+ interface, image
and data
USB socket,
4-pin, type B USB plug,
4-pin, type B
Tab. 7-1: Interfaces at IndraControl VDP 16.3 and IndraControl VDP 40.3
7.1.2 S1 DIP switch
There is only a DIP switch at devices with a CDI interface. The
DIP switch is not available at devices with CDI+ interface.
Overview
Name at the
housing
Switch type Function
S1/switch 1 DIP switch No function
S1/switch 2 DIP switch OFF: Cable length to the control cabinet
PC < 30 m
ON: Cable length to control cabinet PC >
30 m
Tab. 7-2: DIP switch at the VDP
Operating Modes
Cable length max. 5 m between control cabinet PC and VDP
If the distance to the control cabinet PC does not exceed 5 m, the USB
connection to the VDP can be executed in the USB 2.0 mode (High Speed,
max. 480 Mb/s) by using an additional USB 2.0 cable. The S1 switch 2 must
be in the "OFF" position. If the cable is not used, the USB connection is
executed using USB 1.1. (max. data rate at full speed: 12 Mb/s).
Cable length max. 30 m between control cabinet PC and VDP (stand‐
ard USB mode)
The USB connection is executed in the USB1.1 mode. The S1 switch 2 must
be in the "OFF" position.
36/57
Interfaces
IndraControl VDP 16.3, VDP 40.3, VDP 60.3 Operator Dis‐
play
Bosch Rexroth AG R911323862_Edition 07