Bosch Rexroth IndraControl VCP 05.2, Руководство по планированию проекта

Страница: 38 / 78

6 -6 Bosch Rexroth AG | Electric Drives and Controls Rexroth IndraControl VCP 05 | R911310377 / 02
Display and Operating Components
6.2.4 Function Keys
6.2.4.1 Slide-in Identification Strips for the Function Keys
The identifications strips can be replaced when the operating device is
built-in or removed. Inserting the strip from the rear side of the front
plate does not influence the specified seal of the operator terminal. A
set of identification strips is supplied with the operator terminal.
For the labeling use:
Fig. 6-2: Position of the slide-in identifications strips
Fig. 6-3: Set of slide-in identifications strips
The function of function keys can be assigned as required (softkey func-
tionality). The function keys can optionally be used as direct selection
keys for menu control or to trigger a function in the controller.
Single pieces, prototypes Label with a water-resistant pen
Small series Copying foil (thickness <= 70 µm) with
laser print
Large series Customer-specific labeled identification
strips